Chiroptical detection during liquid chromatography,part 5: On-line measurement of circular dichroism spectra Δε(λ) during stops of chromatographic flow

Summary A procedure is described which serves to measure circular dichrograms () on line during stops of flow in liquid chromatography. Since the concentration of substrate in the spectrometer cell during the stop is not known, the differential absorption coefficients are calculated from the experimental differential absorbances A by means of UV absorption (i. e. photomultiplier voltage) data. Verifications of the procedure are obtained by its application to three substrates (Table 1), the () spectra of which were known. The present on-line technique is compared with a corresponding off-line method.The N,N-dimethylthiobenzamides1 and2 as well as the 9,10-phenanthrenequinone7 consist of interconvertible enantiomers because their planar states are destabilized by steric overcrowding of groups. The unknown dichrograms () of1, 2 and7 are obtained (Figs. 2 and 4) and discussed with reference to the helicities of these molecules.In memory of the late Professor Dr. Dr. h. c. Günther Snatzke.     

Fluordiazadiphosphetidine, 11. Mitt.: Eine neue Methode zur Herstellung der doppelt zwitterionischen Verbindung (CH3N)6P4F8

A new synthetic route for the preparation of the betain-like compound (CH₃N)₆P₄F₈ from (CH₃NPF₃)₂,N-methyl-hexamethyldisilazane andN,N-dimethyl-urea has been found. The steps of this multi-stage reaction could be rationalized to a far extent.

10. Mitteilung:Kubjacek M., Utvary K., Mh. Chem.112, 305 (1981).     

Die Phase La2U2N5

In the system U–La–N a new phase of composition La₂U₂N₅ was observed. The differaction pattern of this phase can be indexed with a tetragonal unit cell:a=8.43 Å,c=8.50 Å andc/a=1.008. The pseudocubic sub-cell withaca/2 is closely related to the CsCl-type.

Auszug aus der von der Technisch-Naturwissenschaftlichen Fakuktät der TU Wien approbierten Diplomarbait des Herrn Dipl.-Ing.J. Waldhart.     

Application of a micro carbon rod atomizer as Br-spezific gas-chromatographic detector

Summary A micro carbon rod atomizer has been employed for specific and quantitative bromine determinations. This Br-specific gas-chromatographic detector works by help of InBr-bands and measurement at 372.7 nm. The performance of this flame band emission detector (FBD) is demonstrated by calibration curves and the detection limits of 2 examples (ethyl bromide, ethylene dibromide), the latter being 5 and 36 ng of bromine, respectively. The reproducibility has been found to be 4.3%. An example of this detector in comparison with a thermoconductivity detector (TCD) is presented.

---

Verwendung einer Mikro-Graphitküvette als Br-spezifischer Detektor für die Gas-Chromatographie

Zusammenfassung Eine Mikro-Graphit-Küvette wird für spezifische quantitative Brombestimmungen nach der Indium-Methode bei 372,7 nm benützt und in Verbindung mit einem Gas-Chromatographen als Br-spezifischer Detektor eingesetzt. Die Leistungsfähigkeit dieses Detektors wird an 2 Beispielen (Äthylbromid, Dibromäthan) mit Hilfe von Eichkurven, Bestimmung von Nachweisgrenzen u. ä. demonstriert. Die Nachweisgrenzen liegen bei 5 bzw. 36 ng Brom für die 2 genannten Substanzen. Die Reproduzierbarkeit der Messungen liegt bei 4,3%. Ein Beispiel für die Registrierung eines Gemisches verschiedener Substanzen, gemessen mit dem GC + Flammen-Banden-emissions-Detektor (FBD) und zum Vergleich mit einem Wärmeleitfähigkeitsdetektor (TCD), wird dargestellt.

This research work was supported by financial help of the Bundesminister für Forschung und Technologie in Bonn (GFR).     

Vibrational spectra,normal coordinate analyses,and molecular configurations of crystalline propionic acid

Temperature dependence of the IR spectra of crystalline propionic acid were examined in the temperature range 242–50 K. The intensities of most absorption bands increased on lowering the temperature, but some bands diminished until they disappeared at temperatures lower than about 120 K. Normal coordinate analyses indicate that the former bands are due to the stable cis dimer and the latter due to the less stable trans dimer which would be produced from the cis dimer by simultaneous proton transfer along two hydrogen bonds.     

Insights on the origin of the structural phase transition in BaV10O15 from electronic structure calculations and the effect of Ti-doping on its structure and electrical transport properties

Band structure calculations at the level of LMTO-ASA provide insight into the electronic structure of BaV₁₀O₁₅ and the origin of the structural phase transition. A crystal orbital Hamiltonian population/integrated crystal orbital Hamiltonian population analysis provides evidence that the crystallographic phase transition is driven by V-V bond formation. As well, the energy bands near the Fermi level are very narrow, <1 eV, consistent with the fact that the observed insulating behavior can be due to electron localization via either Mott-Hubbard correlation and/or Anderson disorder. The partial solid solution, BaV_10−xTi_xO₁₅, was examined to study the effect of Ti-doping at the V sites on the structure and electronic transport properties. In spite of the non-existence of “BaTi₁₀O₁₅”, the limiting x=8, as indicated by a monotonic increase in the cell volume and systematic changes in properties. This limit may be due to the difficulty of stabilizing Ti²⁺ in this structure. For x=0.5 both the first order structural phase transition and the magnetic transition at 40 K are quenched. The samples obey the Curie-Weiss law to x=3 with nearly spin only effective moments along with θ values which range from −1090 K (x=0.5) to −1629 K (x=3). For x>3 a very large, ∼2×10⁻³ emu/mol, temperature independent (TIP) contribution dominates. Conductivity measurements on sintered, polycrystalline samples show semiconducting behavior for all compositions. Activation energies for Mott hopping derived from high temperature data range from ∼0.1 eV for x=0-1 and fall to a plateau of 0.06 eV for x=3-7. Low temperature data for x=3, 5 and 7 show evidence for Mott variable range hoping (VRH) with a T^1/4 law and in one case between 5 and 17 K, a Efros-Shklovskii correlated hopping, T^1/2 law, was seen, in sharp contrast to BaV₁₀O₁₅ where only the E-S law was observed up to 75 K. Seebeck coefficients are small (<35 μV/K), positive, roughly TIP and increase with increasing x up to x=5. This may point to a Heikes hopping of holes but a simple single carrier model is impossible. The compositions for x>3 are remarkable in that local moment behavior is lost, yet a metallic state is not reached. The failure of this system to be driven metallic even at such high doping levels is not fully understood but it seems clear that disorder induced carrier localization plays a major role.     

Stability of the FID sensitivity during an analysis in capillary GC

The sensitivity of an FID may change when the carrier gas flow rate changes during a chromatographic run. Sample parts which are eluted at reduced FID sensitivity produce a reduced peak area, hence are discriminated as compared to other components. Sensitivity changes were studied for hydrogen as carrier gas. For the detector tested, differences in the carrier gas flow rates of 1 ml/min shifted the FID sensitivity by 1 to 5% (depending on the fuel gas supply). Thus the stability of the sensitivity is no longer ensured as soon as the carrier gas flow rate is changed manually or by an automatic programmer during an analysis. Sensitivity drifts may also occur during temperature programmed runs with a pressure regulated carrier gas supply since the gas flow through the capillary drops with increasing temperature. Such shifts in the response became noticeable as soon as relatively high carrier gas flow rates combined with long range temperature programmes were used. The typical patterns of such discriminations are shown, closing with a discussion on the possibilities for minimizing such undesired effects.     

纳米二氧化硅标准物质候选物的制备

以正硅酸乙酯和去离子水为反应物,氨水为催化剂,乙醇为共溶剂,通过沉淀反应制备窄分布的纳米二氧化硅标准物质候选物。利用扫描电子显微镜分析考察了氨水的用量对制备的二氧化硅粒度的影响。     

Determination of Labile Iron at Low nmol L−1 Levels in Estuarine and Coastal Waters by Anodic Stripping Voltammetry

A new method is presented for the determination of electrochemically labile iron in estuarine and coastal seawater. The method is based on differential pulse anodic stripping voltammetry (DPASV) at a rotating silver‐alloy disk electrode. The voltammetric parameters include a plating potential of ?1.5 V and an activation potential of ?5 V for 10s; the seawater is at the original sample pH. The main finding is the presence of a peak for low nmol L^?1 levels of iron at ?0.55 V ascribed to elemental iron deposited on the bare silver alloy electrode. The peak increased linearly with the iron concentration between <1 and 14 nmol L^?1 using a 900 s plating time. At higher concentrations an additional iron peak appeared at ?0.7 V which was also found to increase linearly with the iron concentration but at a higher concentration range from ca. 15 to 90 nmol L^?1 using a 300 s plating time. The second peak was ascribed to iron deposited on iron. Additions of chelating agents (EDTA and a siderophore) to seawater caused the iron peak to be masked indicating that this method is suitable for iron speciation as only the electrochemically labile fraction is determined. The detection limit was 0.3 nmol L^?1 using a 900 s plating time. The method was used to determine iron in the range of 5 to 50 nmol L^?1 in samples from the Mersey estuary near Liverpool and its potential use for in situ monitoring was demonstrated by using it to monitor labile iron (at 2–3 nmol L^?1) over a period of 4 days at 1 h intervals in coastal waters in the Trondheim fjord, Norway.     

由非晶态Ni-P低温制备Ni2P催化剂及其对二苯并噻吩加氢脱硫的催化性能

 以非晶态Ni-P合金为前驱体,在低温下通过PH3处理制备了Ni2P/SiO2-Al2O3催化剂,并用X射线衍射(XRD)、 透射电镜(TEM)、 电感耦合等离子体发射光谱、 N2吸附和X射线光电子能谱(XPS)进行了表征,以二苯并噻吩为探针,在小型连续流动固定床反应器上考察了催化剂的加氢脱硫性能. XRD结果表明,在200～300 ℃范围内前驱体都可以完全转化为Ni2P, 随着磷化温度的升高,晶体结构变得越来越完整. TEM观察发现, Ni-P粒子和Ni2P粒子的平均尺寸都在40～50 nm, 并且都能够高分散在SiO2-Al2O3载体上. XPS结果表明,不论是非负载还是SiO2-Al2O3负载的Ni2P, 表层主要为Ni2P和钝化层Ni3(PO4)2. Ni2P/SiO2-Al2O3催化剂在实验范围内表现出很好的二苯并噻吩加氢脱硫性能.